There's JB Weld and JB Kwik.The Kwik stuff has the 5 minute working time. The
other often has an annoyingly too long working time, running off or settling
into low areas while you're wishing it would hurry and gel. The slow version
does achieve a higher final strength, but takes at least 24 hours before you
can put any stress on it.
Loctite also makes a couple of epoxy compounds similar to the JB ones.
From: Gene Heskett <[email protected]>
To: [email protected]
Sent: Friday, April 8, 2016 5:43 AM
Subject: Re: [Emc-users] Found my backlash
On Friday 08 April 2016 07:25:05 andy pugh wrote:
> On 8 April 2016 at 04:44, Gene Heskett <[email protected]> wrote:
> > Should I also stir up some JBWeld and give the leg and its socket a
> > coat of that for even more permanence? I don't know that I could get
> > it tight before the JB is setup though. That stuff is pretty fast
> > setting.
>
> The JB-weld will not squeeze out to a zero-thickness layer, so will
> probably affect alignment.
>
> And if it did set before you had things together, how would you
> rectify the problem?
As Jackie Gleason would have said, "what a revoltin development that
would be". :)
But I also thought if it was fresh enough, it should squeeze out to not
more than a thou thick if the bolts didn't waste any time being torqued.
But with its 5 minute set time, I doubt if I could get it in there
quickly enough. Whatever I'd put in there would have to be of an
injectable viscosity, and JBWeld sure isn't. So I may settle for some
red locktite on the screws. If that fails, then we'll know for sure the
washers are bending.
------------------------------------------------------------------------------
Find and fix application performance issues faster with Applications Manager
Applications Manager provides deep performance insights into multiple tiers of
your business applications. It resolves application problems quickly and
reduces your MTTR. Get your free trial! http://pubads.g.doubleclick.net/
gampad/clk?id=1444514301&iu=/ca-pub-7940484522588532
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
