Hi, You just need to use G21 in Gcode, that's all!
If you switch to mm in INI file, you'll have to convert machine limits and velocities to mm. 2016-05-29 23:05 GMT+03:00 a k <[email protected]>: > Hello > i am using linux cnc 2. 6. 4 > and i have problem with switching to machine to read program G code in mm. > i did went into INI and change inch to mm > i did restart - re-home CNC machine > in the program i did replace G20 to G21. > And i can not load mm g code-- it say travel out of range. > > ////// > i found that if in INI file i leave INCH, and re start LCNC and in one line > with MDI command input > G91 G21 G1 x-5. F20. > machine moves 5. mm, > but when i try to set G55 ...in mm machine does not moves > > Is it known problem ? > How to fix it? > > > thank you > aram > > ------------------------------------------------------------------------------ > What NetFlow Analyzer can do for you? Monitors network bandwidth and > traffic > patterns at an interface-level. Reveals which users, apps, and protocols > are > consuming the most bandwidth. Provides multi-vendor support for NetFlow, > J-Flow, sFlow and other flows. Make informed decisions using capacity > planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
