it works. thank you aram On Sun, May 29, 2016 at 2:00 PM, Andrew <[email protected]> wrote:
> 2016-05-29 23:49 GMT+03:00 a k <[email protected]>: > > > Hi > > the problem in setting G56 for example > > > > to set G56 in mm i input in MDI > > G10 L2 P3 X-20. Y-10. Z -5. > > this dimensions in mm. > > when set G56 and input line above, how LCNC knows that i in mm. or in > inch > > ? > > > > maybe when one want to use mm. and set G56 .... need to be change INI all > > into mm? > > > > What if you send G21 in MDI before all that? > > Also you can use RS274NGC_STARTUP_CODE = G21 in INI file. > > http://linuxcnc.org/docs/2.6/html/config/ini_config.html#sub:RS274NGC-section > > ------------------------------------------------------------------------------ > What NetFlow Analyzer can do for you? Monitors network bandwidth and > traffic > patterns at an interface-level. Reveals which users, apps, and protocols > are > consuming the most bandwidth. Provides multi-vendor support for NetFlow, > J-Flow, sFlow and other flows. Make informed decisions using capacity > planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
