Hello i just run kissliser http://www.kisslicer.com/ and many people use it because it free (some realize free )
here is how main code looks like G1 X-2.89 Y29.74 E2.48 G1 X0.49 Y29.72 E2.1506 G1 X4.23 Y29.5 E2.3874 G1 X7.73 Y29.13 E2.2395 G1 X11.56 Y28.58 E2.4618 G1 X14.92 Y28 E2.1725 G1 X18.51 Y27.24 E2.3375 G1 X22.09 Y26.24 E2.3664 /////////////////////////////////////////////////////////////////////////////////////////////////////////////////// regular X and Y and after layer complete Z move incrementally up. And here is also E parameter that increase or decrease speed of wire/ filament.. Can LCNC make LCNC 3d printer ready and make output for E parameter ? like rated from 0 V DC to 5 V DC. that will proportionally indicates speed of plastic filament /wire . Looks similar how i stop LCNC with 0-5 V DC but in this case LCNC will sent frequency out that will converted into 0 - 5 v DC or use just PWM for control filament or wire etc. LCNC can use 2 boards 5I20 , there are 4 more encoder channels that can be used for this purpose. Thak you aram ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
