maybe non-machinists/new-machinists could use a list of good tools maybe a wiki page? whats your goto tools?
mine Starret 6" pocket scale decimal inches Helios vernier ( not even dial ;-) NSK 1-2-3 mike set with standards Starret deep mike ( blade type for mold ribs) Indicol and Noga indicator holders Tesa and Compac geneve indicators Suburban angle plates, vises, and parallels KantTwist clamps Bear (norton) round flat stone to clean table Arkansas White stone for HScutters good tools aint cheap, instead they are good ;-) maybe suggest...not the best stuff, but the middle ground good bang for the buck stuff regards tomp tjtr33 On 10/31/16 19:03, Leonardo Marsaglia wrote: > 2016-10-31 8:28 GMT-03:00 andy pugh <bodge...@gmail.com>: > >> My little digital caliper is playing up. It could just be a low >> battery, it has been flashing the LCD for at least a year. >> (As an aside, why do they run normally for about a week then flash the >> display for about a year?) >> Anyway, moving the slider very slowly it goes from 0.3995" straight to >> 1.200", then acts a bit random until it switches from 1,499 to a >> (correct) 0.800" >> Which surprised me, I had assumed that the basic units of the scale >> were metric. >> > Is this a Mitutoyo one? I have one of these that was purchased in 1993 and > it works quite well except when there's a lot of humidity and you have to > clean the travel surface because it starts to jump numbers giving > ridiculous readings. This also happens when the battery is low. > > I also tried a cheap chinesse one but it's was a disaster. Then I found > these Mitutoyo that are extremely cheap and come from China but I don't > know what to think. > > http://www.ebay.com/itm/Mitutoyo-500-196-20-30-300mm-12-Absolute-Digital-Digimatic-Vernier-Caliper-/331999662209?hash=item4d4cb8d081:g:jRQAAOSw-CpYAH26 > > ------------------------------------------------------------------------------ The Command Line: Reinvented for Modern Developers Did the resurgence of CLI tooling catch you by surprise? Reconnect with the command line and become more productive. Learn the new .NET and ASP.NET CLI. Get your free copy! http://sdm.link/telerik _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users