On Thursday 22 December 2016 08:12:54 andy pugh wrote: > On 22 December 2016 at 12:44, Gene Heskett <[email protected]> wrote: > > it still fails and that logfile is attached. The loadrt line is > > complete with config= argument. I'll take that back out. No diff, > > not even in the logfile. > > I think you might need to reboot after a failed attempt, there is no > guarantee that even a good config will load without error after a bad > config has failed. > (and there is some evidence that you are not getting the same error > every time)
I did, no diff. The failure to load the hm2_rpspi driver, which according to its man page, is specific to the 7i90HD board and doesn't need a BOARD or firmware= argument, is specific to the linuxcnc environment, while if loadrt'd by a halcmd, works perfectly. What is the difference? The clues s/b in that logfile I sent. Thanks Andy. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Developer Access Program for Intel Xeon Phi Processors Access to Intel Xeon Phi processor-based developer platforms. With one year of Intel Parallel Studio XE. Training and support from Colfax. Order your platform today.http://sdm.link/intel _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
