Tabs are probably a very good idea, it is easy to switch in between. Even though my knowledge about EDM machining is very limited to to select parameter from a file or database sounds like a really good idea, I have seen tables with parameters in manual.
If there are any problems with the software I will try to help. I have three cables for digital outputs to solder and need to connect the EDM generator again then my machine is ready to test for the first time. I also lack dielectricum storage tank and pump but that's a minor problem then I got the machine running. On Fri, 30 Dec 2016 02:01:28 +0700 TJoseph Powderly <[email protected]> wrote: > planning 3 tabs > 'tech' you select edm parameters from a flatfile database OR rool your > own on/off/current/polarity/ignition voltage > 'cut' you control live cut generator on/off, offtime, target voltage, > gain for edm servo, peck cutting parms, fill(flood) & flushing parms > and you monitor AvgVoltage AvgCurrent Stability Arcing ... ooops it > 2am, cutting it short > 'strategy' orbiting > > tomp tjtr33 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
