On 27 January 2017 at 02:45, Dan Bloomquist <da...@lakeweb.net> wrote: > So what > I think I need is the Mesa 7i48. 6 channel servo output with quad > encoder inputs. but what I'm not sure about is which of the anything i/o > board I should use. I'm guessing that I don't need that much horse > power and the likes of the 5I24-25-SP should do?
I like the 5i24, it's a lot of pins for not much money, and I have one in my lathe. However, you should also look at the 5i25 / 7i77 combo. Also check out Pico PPMC and the General Mechatronics stuff. Both also well-supported by LinuxCNC. -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users