On Monday 06 February 2017 14:47:04 Andrew wrote: > Hello, > > I want to try 7i90HD on my Raspberry Pi 2. I think Gene did that > recently with Pi 3, so I digged through the list... but the > information is a bit sparse. Also a lot of outdated info on the net. > Please help me figure it out. > > First, I need to get LinuxCNC running: > > 1. Install a raspbian image. One of these? > https://www.raspberrypi.org/downloads/raspbian/ > Or this? > https://sourceforge.net/projects/minibian/ > > 2. Install preempt-rt kernel and headers > http://deb.machinekit.io/debian/pool/main/l/linux-rt/linux-image-rpi2- >rt_4.4.4-rt9-v7+-7_armhf.deb > http://deb.machinekit.io/debian/pool/main/l/linux-rt/linux-headers-rpi >2-rt_4.4.4-rt9-v7+-7_armhf.deb > > 3. Install jessie master-sim from the buildbot. > > Anything else? > Ask Matsche if his rpspi.so driver will run on a pi 2. Differences in the gpio architecture may preclude that as the data rate on that bus when its working is at 32 megabites a second while its flowing in 4, 8 byte packets. per transaction.
> Thanks, > Andrew > ---------------------------------------------------------------------- >-------- Check out the vibrant tech community on one of the world's > most engaging tech sites, SlashDot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
