On Wednesday 08 February 2017 09:04:25 andy pugh wrote: > On 7 February 2017 at 22:39, Sebastian Kuzminsky <[email protected]> wrote: > > Feel free to pitch in and donate a reliable, fast armhf build > > machine to the linuxcnc buildbot if this is important to you. > > I am (maybe surprisingly) fuzzy on what constitutes Armhf. But I am > wondering if the Udoo Quad might be a good choice, as it has a nice > big heat-sink: > http://shop.udoo.org/usa/quad-dual.html?___from_store=other&popup=no
Thats not an armhf, Andy, thats intels latest tiny & low power consumption board, but it speaks x86, not armhf. It would I think. make a heck of a controller board since the top of the list does have 76 gpio's, so one wouldn't need a bob to use it. > I got one with an eye to LinuxCNC use, but it turned out that the link > between the Arduino part and Linux part was USB and so not very > realtimey. > > (This doesn't actually make it useless, the PC can drive the > Arduino-shaped IO directly). Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
