On 02/25/2017 02:17 PM, Tomaz T. wrote:
> I'm in doing a little research on replacing "low pitch" slow ballscrews with 
> faster R&P and found this anti backlash system:
>
>
> https://www.damencnc.com/en/components/mechanical-parts/rack---pinion/320
>
>
>
> Does anyone here use it, and is it worth of investment compared to single 
> pinion "standard" drive?
>
>
It works! It's nothing new. Two servos are used where one drives the
pinion gear and the other acts as a slave on a second pinion preloading
the rack to remove the backlash.

http://www.atlantadrives.com/systems1.htm

http://machinedesign.com/motorsdrives/separating-rack-and-pinion-myths-reality

-Bari




------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to