Spam. I was trying to avoid Google always watching and registrering all you do. That is the reason why I try to use protonmail. Tanks a lot for info about the spam filter.
Pncconf. Thank you for info about the firmware control of the pins. That saved me a lot of time. When you are new to 5i25 the Mesa manual is not very clear about this. My intention was to replace the par port with the 5i25. I can see some hardware chances may be neccessary when some of the pins have fixed functions. -------- Original Message -------- On 13. mar. 2017 21.39, andy pugh wrote: Sorry, this message got sent to spam because of "Why is this message in Spam? It has a from address in protonmail.com but has failed protonmail.com's required tests for authentication." (This means that your ISP does not understand about mailing lists) This might be why you got no replies. On 18 February 2017 at 17:19, Tiklack <tikl...@protonmail.com> wrote: > If you are looking into the generated HAL file there seems to be no signals > for step pulses? When a parallel port and Stepconf is used you get an "xstep" > signal connected to the step pulse input of the motor drive. That is correct. The routing of the step pulses to output pins is configured by the FPGA firmware, it is not routed through HAL. The HAL interface is just position or velocity commands and scale and timing parameters -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
