On Wednesday 15 March 2017 14:07:08 andy pugh wrote: > On 15 March 2017 at 15:50, Gene Heskett <ghesk...@shentel.net> wrote: > > I've looked at that Andy. I note it can't be named in the loadrt > > line. So I assume if several were used, they would be > > mux-generic.0., .1.,.2. > > Actually, they get shortedned to mux-gen.00.... etc. > > > etc? Whats its execution time when it has to convert? IIRC what I'd > > need would be fs or sf conversions. > > It should be no slower than a separate conversion component, and most > probably quicker.
That was my reasoning too, Jon. And now, advice wanted. The encoder counts + when turned cw. But following the rules of the road, that backs the crossfeed out. I reversed it, but that doesn't quite seem correct either. Which is correct? I want it as close to hands on the crank as I can get it, until the timedelay times out anyway. Another oddity, until I have moved it by a short keyboard jog, the dial is completely ignored. I can adjust the gain, but the counts fed to the jog-count input are ignored. Now, to go make z work just like it. But while I was playing just now, I ran htop in a 2nd shell, and found that linuxcnc wasn't even in the top 25 for cpu loading! The X compositor, named compton, was burning up as much as 185% of the 4 cores. 150+ just sitting there doing squat. So obviously the video is the biggest hog in the snake pit that is the pi video, by a >10/1 margin. Neither glx, nor drm are working, so the video has a detectable lag. Frame rate is perhaps 15/second at best. So I have to pester the debian-arm folks to get that fixed. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
