On 04/05/2017 09:30 AM, Todd Zuercher wrote: > I still have (had) 2 machines running Linuxcnc on Ubuntu 10.04. One of which > seems to be locked into staying with it because of Hardware limitations (an > ISA interface card). In the past week one of those machines started freezing > up while running Linuxcnc. Fortunately it wasn't the machine that can't run > on Wheezy, so yesterday in frustration I installed the Wheezy ISO in a > separate partition and that seems to have stopped the problem. My other old > installation is still working happily. One of the main differences between > the two machines is the one that was acting up has a Gladevcp, and the one > that is still working has a Pyvcp. Where should I start looking for debugging > info, to help find what is going wrong on the one machine? > First, I'd run memtest86 for a couple hours. Then, I might reseat all I/O cards and memory. Most likely, if a machine BEGINS to act up after working reliably for a long time, it is NOT software.
Jon ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
