On Sun, 2017-04-23 at 16:42 +0200, Valerio Bellizzomi wrote: > Hello, > I have found the parameters here > http://wiki.linuxcnc.org/cgi-bin/wiki.pl?Stepper_Drive_Timing > > and wrote them in the .ini file, tested the motor and it still > vibrates. > >
well well, apart of timing there is the P parameter which is important pncconf wrote a P value of 10000, which is too high and make the motor vibrate I wrote a P value of 100, that resolved the problem. completely. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
