Slic3r and cura both run on linux. I use them inside Repetier-host, which also runs fine under linux.
-- Ralph On May 16, 2017 4:43 AM, giorgio foga <giorgiof...@hotmail.it> wrote: Hi, anyone can suggest me a good cam for additive manufactoring .. (fdm) ... free or payment not so important, but just need to install it on linux... regards goirgio ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users