All, Never mind. Working now. I swapped 7i33 boards. Should go back to the other board and make sure I was doing exactly the same thing.
Regards, Eric On August 18, 2017 1:52:58 PM EDT, "Eric H. Johnson" <ejohn...@camalytics.com> wrote: >All, > >I am not seeing the analog output values change on the Mesa 7i33TA >daughter board from the default 7i43-big configuration. I should see it >across pins 9 & 10. > >This is from Linuxcnc 2.8.0-pre1 running on Xubuntu 12.04. > >I tried decoupling the analog output from the configuration as follows: > >Commented out: >net motor.00.command pid.0.output => >hm2_[HOSTMOT2](BOARD).0.pwmgen.00.value > >And replaced with > >net MotorXval => hm2_[HOSTMOT2](BOARD).0.pwmgen.00.value > >Not sure if the enable is necessary, but is working as the amplifier >does turn on. > >I would think that if I then do > >halcmd sets MotorXval 0.5 > >I should see the voltage output across pins 9 and 10 change >accordingly. I am not seeing any change. Am I missing something in the >way I am trying to test this. > >Encoders, and basically everything else seems to be working. > >Thanks, >Eric >-- >Sent from my Android device with K-9 Mail. Please excuse my brevity. >------------------------------------------------------------------------------ >Check out the vibrant tech community on one of the world's most >engaging tech sites, Slashdot.org! http://sdm.link/slashdot >_______________________________________________ >Emc-users mailing list >Emc-users@lists.sourceforge.net >https://lists.sourceforge.net/lists/listinfo/emc-users -- Sent from my Android device with K-9 Mail. Please excuse my brevity. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
