All, I am not seeing the analog output values change on the Mesa 7i33TA daughter board from the default 7i43-big configuration. I should see it across pins 9 & 10.
This is from Linuxcnc 2.8.0-pre1 running on Xubuntu 12.04. I tried decoupling the analog output from the configuration as follows: Commented out: net motor.00.command pid.0.output => hm2_[HOSTMOT2](BOARD).0.pwmgen.00.value And replaced with net MotorXval => hm2_[HOSTMOT2](BOARD).0.pwmgen.00.value Not sure if the enable is necessary, but is working as the amplifier does turn on. I would think that if I then do halcmd sets MotorXval 0.5 I should see the voltage output across pins 9 and 10 change accordingly. I am not seeing any change. Am I missing something in the way I am trying to test this. Encoders, and basically everything else seems to be working. Thanks, Eric -- Sent from my Android device with K-9 Mail. Please excuse my brevity. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users