Not sure what the conditions are but I dont remember any restrictions.
Please PM me for the link.
------ Original Message ------
From: "Chris Albertson" <[email protected]>
To: "Marius Liebenberg" <[email protected]>; "Enhanced Machine
Controller (EMC)" <[email protected]>
Sent: 2017-10-13 20:52:23
Subject: Re: [Emc-users] Path Pilot on LinuxCNC -- Was MachineKit on the
BeagleBone Black
I assume it is redistributable. Can you place the data some place
where others can see it?
On Fri, Oct 13, 2017 at 4:30 AM, Marius Liebenberg
<[email protected]> wrote:
I have a source code CD that I paid $10 for to cover shipping and
other costs.
Tormach says they don't support path pilot on 3rd party equipment.
It
likely
depends on specialized hardware so it would not run without
modification
and I don't think they have source code available.
As a derivative of a GPL licensed project I thought that they would
be
required to make the source available.
Has anybody asked for the source to see what they say? The little I
have
dealt with them they
always seemed very forthcoming with information and to be straight
forward
and honest folks.
Cheers,
Kurt
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
--
Chris Albertson
Redondo Beach, California
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
