On 12/16/2017 12:53 PM, Danny Miller wrote:
Every time you hit Start, before it starts the spindle or
actually runs any line of the user G-code, it jogs over to
a tool height sensor (THS) and probes for the installed
tool height
If you did this like a homing move, only the tool height
sensor sets the Z home position, and the axis soft limits
are such that MIN_Z = 0.0, then it would be impossible to
cut into the spoil board.
Jon
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
