> On 4. Apr 2018, at 21:57, John Dammeyer <jo...@autoartisans.com> wrote:
> 
> The STMBL AC Servo drive I'm currently working with has an ENABLE high input. 
>  So when Low it's disabled and stepping pulses can't move the motor.

its not supposed to be like that. it should be active low. I will ad a inverted 
pin to the software.
I didn't think about the fact that rs485 termination defaults to 1...
you are the first one using the diff enable signal, most use the smart serial 
connection, and the one setup with step/dir uses a single ended input as enable.

Rene
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to