Re: [Emc-users] Mesa choices

[jeremy youngs]

7i90 and cable should be here tomorrow, timing belts and pulleys on the way
too. I'm going to see if I can get a pinout on these renco encoders , I
figure once the mess card is hooked up I can count the pulse in one
rotation and go from there. Pretty busy the next few days so it will be mid
week before I really get to focus energy on this. Exciting times, sure more
questions to come. I'm going to get a dead tree copy if the lcnc manual and
the integrator manual done up in the next week or so. TTYL
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users