Greetings all I'm going to try something thats probably crazy, and until the mail brings me a 7i76D expected tomorrow maybe I'm going to assmue it will work.
What I'm going to do since there is no pdm output in a 7i76(D), I've been studying pin files. And it looks like I might be able to use the 7i76_7i78 firmware in the 5i25, putting a 7i76D on p3, and a normal BoB on p2, where it will then feed me the signals from a PWMGen in the 5i25 on p2, on out to do my spindle control. So I've programmed a 5i25 as above. The 7i76 gives me 4 stepgens using the config at the bottom of my .ini file now, so thats handled, all I need to do is pull the wires from the bob now on p3, and move then to the same pins on the p2 bob. Question for the experts: The present config doesn't mention the sserial's stuff, supposedly ack the pin files there are three and those 4 pins for 2 circuits to the 7i76 do NOT show in the dmesg, does that need to be in the config? Example .ini file config line plz. Humm, may be a doofus question, it seems the sserial ports may not show unless they are hooked up, kinda hard to hook up a card that still in an ifitfits box someplace west of here. "num_sserials=2" is a syntax error atm. Thanks everybody. -- Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
