Details below: any recommendations/advice will be greatly appreciated.
Sorry for the copious verbiage but .....
uname -a gives:
linuxcnc 3.4-9-rtai-686-pae #1 SMP PREEMPT Debian 3.4.55-41linuxcnc i686
i686 9386 GNU/Linux
from memory linuxcnc v. 3.7.8
5i20/7i33/7i37
attached is the screenshot after shutdown of linuxcnc; hope it comes thru
Since I'm using servo's this does not seem to visibly impact
performance; however, the linuxcnc will randomly shutdown.
I just completed 17 hours of memtest with out with no errors so
something else is going on.
Bios setup is as per below :-) Thanks for helpful people.
MAIN PAGE:
Intel Hyper-Threading Technology - <DISABLE>
BOOT CONFIGURATION:
Numlock <ON>
System Fan Control <DISABLE>
System Fan Speed <100%>
Max CPUID Value Limit <DISABLE>
Display Setup Prompt <ON>
Display POST Codes <ENABLE>
PERIPHERAL CONFIGURATION:
Serial Port <DISABLE>
Parallel Port <ENABLE>
Mode <EPP>
Audio <DISABLE>
On-Board LAN <ENABLE>
INTERNAL CHIPSET DRIVE CONFIGURATION:
Configure SATA as <IDE>
S.M.A.R.T. <ENABLE>
Hard Disk Pre-Delay <0>
EVENT LOG:
Clear Event Log <DISABLE>
Event Logging <DISABLE>
VIDEO CONFIGURATION:
DVMT Mode <DVMT>
IGD DVMT Memory <256 MB>
IGD Aperture Size: 256MB
Primary Video Adapter <Int Graphics (IGD)>
CHIPSET CONFIGURATION: NOTE: THIS BLOCK NOT SET!
PCI Latency Timer <32>
HPET <ENABLE>
USB CONFIGURATION:
USB Ports <ENABLE ALL>
USB LEGACY <DISABLE>
SECURITY:
Expansion Card Text <DISABLE>
Execute Disable Bit <ENABLE>
POWER:
After Power Failure <STAY OFF>
Wake on LAN from S5 <STAY OFF>
ACPI Suspent State <S1 STATE>
S1 State Indicator <ON>
MAIN PAGE:
Intel Hyper-Threading Technology - <DISABLE>
BOOT CONFIGURATION:
Numlock <ON>
System Fan Control <DISABLE>
System Fan Speed <100%>
Max CPUID Value Limit <DISABLE>
Display Setup Prompt <ON>
Display POST Codes <ENABLE>
PERIPHERAL CONFIGURATION:
Serial Port <DISABLE>
Parallel Port <ENABLE>
Mode <EPP> (Note, I read EPP should be used for those people who run a
Gecko G540, like me)
Audio <DISABLE>
On-Board LAN <ENABLE>
INTERNAL CHIPSET DRIVE CONFIGURATION:
Configure SATA as <IDE>
S.M.A.R.T. <ENABLE>
Hard Disk Pre-Delay <0>
EVENT LOG:
Clear Event Log <DISABLE>
Event Logging <DISABLE>
VIDEO CONFIGURATION:
DVMT Mode <DVMT>
IGD DVMT Memory <256 MB>
IGD Aperture Size: 256MB
Primary Video Adapter <Int Graphics (IGD)>
CHIPSET CONFIGURATION:
PCI Latency Timer <32>
HPET <ENABLE>
USB CONFIGURATION:
USB Ports <ENABLE ALL>
USB LEGACY <DISABLE>
SECURITY:
Expansion Card Text <DISABLE>
Execute Disable Bit <ENABLE>
POWER:
After Power Failure <STAY OFF>
Wake on LAN from S5 <STAY OFF>
ACPI Suspent State <S1 STATE>
S1 State Indicator <ON>
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
