On Wednesday 23 January 2019 18:30:52 andy pugh wrote: > On Wed, 23 Jan 2019 at 23:08, Gene Heskett <ghesk...@shentel.net> wrote: > > Near as I can id it, its a PRT-E1500W, but this one may have a > > longer name. One pcb, sitting on a thick block of alu. > > The internet seems to be full of people saying that they can't get any > useful sort of manual.
Add me to that list Andy, the best I've found is a list of the default settings, often 90+% of the time without a clue as to what that setting actually represents. Although if it says 5.00, one is tempted to treat that as the fla or something similar. Readings above 50.0 I think can be said to be the frequency break point of some control. Interestingly at r031 there is an extra readout, that appears to be the rpm its running at, if it was running. Seems to be effective for the option #2, I didn't notice it at option #1, which one would assume is Analog Frequency Control, as if I was using a SpinX1 to make an analog control voltage. There is also supposed to be an rs485 input but I didn't note if there was an rj-45 or telco style connector for it. I don't have anything attached at the +12 volt output pin, which one would normally feed a SpinX1 from. One normally assumes a pwm signal as switching from ground to + 5 volts, which it is in fact doing. So until I find the Revelations chapter in the thing that passes for a manual, 6-7 pages with pix of the machine, then 15 pages of setup for a usb version of Mach for the 800 watt watercooled motor. I think there's even a crippled version of Mach on the cd. But as you know, I shoot windows on sight... I'll reopen the box tomorrow and see if I can get any schmardter. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
