Gregg, This isn’t exactly what you were asking for, but it might work. CRAMPS-BOB3-a3 <https://oshpark.com/shared_projects/2p1xADDj> It is for the CRAMPS board. Instead of the step/dir/common pins going to a Polulu board, the are shipped over to the output connector on the CRAMPS board. So you can use the pin header to run on off board drive. If you are interested I can send you the schematic for the board. If the link above doesn’t work, here is the URL <https://oshpark.com/shared_projects/2p1xADDj>
Alan > From: Gregg Eshelman <g_ala...@yahoo.com> > Subject: Re: [Emc-users] EDA Software (Was: ConFusion 360) > Date: March 23, 2019 at 4:32:59 PM PDT > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> > > > What I've been wanting someone to make are screw terminal breakout boards for > Pololu or StepStick sockets so that Step, Dir, Enable etc connections can be > made to bigger external motor drivers from a CRAMPS, RAMPS and any other > small control board made for use with those little drivers. > On Saturday, March 23, 2019, 3:39:54 PM MDT, andy pugh > <bodge...@gmail.com> wrote: > > On Sat, 23 Mar 2019 at 21:32, Jon Elson <el...@pico-systems.com> wrote: > >> I inherited the CRAMPS board from Charles Steinkuehler, >> which he designed in Kicad. While Kicad is not quite up to >> the level of Protel99, it definitely is getting close. > > The STMBL project uses KiCAD. (Though they started with Eagle I think) > As far as I know there haven't been any KiCAD-caused problems, but my > involvement is fairly peripheral. > > (f you don't know, STMBL is pretty much the perfect retrofit brushless > servo drive, as it will accept nearly any type of motor feedback and > can drive both brushless PM and induction motors. It talks Mesa > smart-serial for an all-digital command and feedback loop, but can > also work with step-dir, RS232 etc) > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
