On Fri, 19 Apr 2019 at 17:08, andy pugh <[email protected]> wrote: > On Fri, 19 Apr 2019 at 15:22, Todd Zuercher <[email protected]> wrote: > > > > I think I like the idea of a solid shrink fit collet. You'd have to > redesign the nose of the collet and the nut a little to fit a snap ring or > something like that to retain the collet in the nut and make it removeable, > > Something along the same lines as the shrink-fit, a solid ER20 > containing an ER11 socket. (ER 25 and ER16 might work too) > > https://a360.co/2ve9NIS > > That's basically what I drew the first time around...
https://ibb.co/dpwVLkB The top part is not the D bit, it's part of the nut. You can see it's thicker. But only the tip of the rod has the 8degree taper. This is to make it easier to machine the inside geometry of the nut as one piece. (my geometry was not accurate though, should have looked up the correct dimensions) _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
