> -----Original Message-----
> From: Ken Strauss [mailto:ken.stra...@gmail.com]
> Sent: September-11-19 5:50 AM
> To: 'Enhanced Machine Controller (EMC)'
> Subject: Re: [Emc-users] MESA 7i92H Power
> 
> There have been some updates and photos added to the CNCzone 7i92
> thread.
> See
> https://www.cnczone.com/forums/tormach-pathpilot-/354420-tormach-
> software.html
> 
Thanks. 
He's done a nice job on his install.
I do agree with the one comment that the MESA up/down for jumpers is a bit 
confusing.  

Should be able to get back to this in a day or so.  I'm in the middle of laying 
out a small interface board that combines and redirects a number of the 
different signals changing TTL signals to RS422 and adding optical 4N25's to 
serve as Open Collector switches for things like reset and fault to the various 
drives.

At the rate this is going I might as well design my own BoB for my specific 
hardware.

John

> 
> 



_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to