Thank you everyone for your responses. 

 I've ordered 5 boards htat of all goes well should be here in about a week.  
Total cost with shipping was $22Cdn.  If I change the two HP_UHU DC Servo 
drives over to Bergerda AC Servo drives then I can see using 4 of them or just 
creating a new custom BoB that does everything I need.  In the long run that 
would take less space.

I'll post pictures of the completed boards when they are done.

John



> -----Original Message-----
> From: Ralph Stirling [mailto:ralph.stirl...@wallawalla.edu]
> Sent: September-13-19 11:50 AM
> To: Enhanced Machine Controller (EMC)
> Subject: Re: [Emc-users] MESA 7i92H Power
> 
> I use oshpark.com or jlcpcb.com for pcb's these days.
> Jlcpcb is in China, but has very fast turn times and
> very low cost.
> 
> -- Ralph
> ________________________________________
> From: John Dammeyer [jo...@autoartisans.com]
> Sent: Friday, September 13, 2019 10:28 AM
> To: 'Enhanced Machine Controller (EMC)'
> Subject: Re: [Emc-users] MESA 7i92H Power
> 
> Where's an inexpensive place to get a couple of small 2.85" x 3.5" double
> sided PC boards made?
> 
> I've designed a small interface board that will optically isolate the
> step/dir/enable signals before they become differential RS422 for the
> STMBL AC Servo Drive.  Along with 5V for the MESA 7i92H and a couple of
> optically isolated transistors to reset the HP_UHU DC Servo drives.
> The board also can be jumpered instead to provide RS422 for step/dir but
> Open Collector drive for Enable and receiving and isolating Open Collector
> Fault from the Bergerda AC Servo Drives.
> So a whole bunch of features in one small DIN rail mountable board.
> 
> Thanks
> John
> 
> 
> 
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users



_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to