On Tuesday 22 October 2019 22:23:05 Dave Cole wrote:

> I'm surprised your not using a pressure pot to spray the coolant.
> You could put an electric valve on the output and pulse it on and off.
> Harbor Freight has a cheap pressure pot/spray gun setup.  Just use the
> pot. Sometimes low tech is good.  :-)
>
> Dave

I was at the hf store in Buckhannon a week ago and wandered around 
looking for something I could use, but the only thing I saw would have 
used a gallon an hour.  Way too much.  My target is about a 5 to l0 lb 
blow, carrying half a cc a minute or less. I figure with this pump, 
being stroked by the pwmgen, I can turn it maybe 1 or 2 revs a minute.

But since the servo period is a millisecond, I can't pulse it at 
4kilohertz, as I wrote earlier, but at a minimum of 1 khz. Banging it 
for a millisec every 50 millisecs ought to be in the usable range.  But 
we'll see. Dry, and hooked to 12 volts, I'd guess it runs about 1.5 rps.  
That would drain the 8 oz coke bottle in 20 minutes and flood the table 
making a mess.  So its got to slow down, a lot. It apparently has a 
planetary reduction in it, my guess is at least 10/1. I'd like the mist 
to be almost self drying. Air consumption will be a problem too as its 
only a cheep 2 horse, 8 gallon compressor. Direct drive, noisy. Needs an 
input muffler. I don't figure it can run 50% of the time and survive an 
hour.
I found a motor driver, s/b 2 of then here next Monday, so the suspense 
will be replaced by making a smaller nozzle for the flex hose. writing a 
bit of hal code and making it work better than what I've got now...

Thanks Dave.

Cheers, Gene Heskett
-- 
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
If we desire respect for the law, we must first make the law respectable.
 - Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/gene>


_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to