On 02/01/2020 08:35 PM, Thomas D. Dean wrote:
I have been using linuxcnc 2.9.0~Pre0 from sources, run in place. Until today, it has worked, mostly. Before today, about 2x per week it would freeze and I had to cycle power to get it working. Now, linuxcnc freezes.

Does it ONLY freeze when LinuxCNC is running? But, just keep working if you DON'T start LinuxCNC? In that case, the most likely problem is the BASE_THREAD has too short a period. Try increasing the BASE_THREAD period in the .ini file and see if that fixes it.

Jon


_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to