On 02/02/2020 05:04 PM, Thomas D. Dean wrote:
On 2020-02-01 20:46, Jon Elson wrote:
On 02/01/2020 08:35 PM, Thomas D. Dean wrote:
I have been using linuxcnc 2.9.0~Pre0 from sources, run
in place. Until today, it has worked, mostly. Before
today, about 2x per week it would freeze and I had to
cycle power to get it working. Now, linuxcnc freezes.
Does it ONLY freeze when LinuxCNC is running? But, just
keep working if you DON'T start LinuxCNC?
In that case, the most likely problem is the BASE_THREAD
has too short a period. Try increasing
the BASE_THREAD period in the .ini file and see if that
fixes it.
I changed the BASE_THREAD period by a factor of 10x then
100x, with the same result.
The OS seems to run fine. I did:
> cd RTAI/linuxcnc
> git pull
> cd src
> make clean
> make
> sudo make setuid
All this went OK. Elapsed time 20 min, or so.
OK, so ONLY your GUI is freezing? One other thing is if you
load a very long and complex toolpath, then the
3D preview window can lock up for a long time.
Jon
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
