> -----Original Message----- > From: andy pugh [mailto:[email protected]] > Sent: April-06-20 1:15 PM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] Gecko Failure > > On Mon, 6 Apr 2020 at 21:07, John Dammeyer <[email protected]> wrote: > > > I checked and from Pheonix any sort of gold flash isn't available. They > > are on 6mm spacing and although installed as a 12 > position I can cut and remove only the 6 on the LHS. But what to replace > them with? > > Maybe a soldered-in cage-clamp header? How useful is unpluggability? > I have an AMP CPC connector at the panel. The motor plugs into that from the outside world. This could run directly to the board and be soldered to the pins. There is absolutely no damage on the CPC connector pins and they've been in service for the same length of time as the driver and motor. John
> -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > � George Fitch, Atlanta Constitution Newspaper, 1912 > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
