I'm going to take it apart one more time I think and remove the solder and resolder the two pins with the crystalized overheated solder joints. Although it might also be better to leave well enough alone.
John > -----Original Message----- > From: Jon Elson [mailto:[email protected]] > Sent: April-07-20 8:38 AM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] Gecko Failure > > On 04/06/2020 06:16 PM, John Dammeyer wrote: > > Then cover back on and all together into the machine. The Z axis works > > perfectly. The drive doesn't get any warmer than it did > before. As in I can hold my hand on the heatsink and it's barely warm. The > connector also does not feel warm nor do the wires. > > > > > Wow, I think you got lucky! But, good news that the driver > is not bad. > > Jon > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
