> -----Original Message-----
> From: Leonardo Marsaglia [mailto:[email protected]]
> Sent: April-29-20 2:49 PM
> To: Enhanced Machine Controller (EMC)
> Subject: [Emc-users] More camshaft turning/external offsets
>
> I installed another tool holder with much more relief and now I can rough
> the lobes in one pass. Here's a video of a one pass rough cut. I'm turning
> the spindle at about 100 RPM and the depth of the cut is 3.5 mm
> approximately.
>
> Here's the video: https://youtu.be/xjBXa6RHSPQ
>
Nice. Cast iron cam shaft? Does it get hardened after? If so how?
John
> _______________________________________________
> Emc-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
