Hello John, Indeed, nodular/ductile cast iron. We harden the cams with induction heating, controlled by LCNC too off course. After that we grind them to the final dimensions.
El mié., 29 abr. 2020 a las 19:03, John Dammeyer (<[email protected]>) escribió: > > > > -----Original Message----- > > From: Leonardo Marsaglia [mailto:[email protected]] > > Sent: April-29-20 2:49 PM > > To: Enhanced Machine Controller (EMC) > > Subject: [Emc-users] More camshaft turning/external offsets > > > > I installed another tool holder with much more relief and now I can rough > > the lobes in one pass. Here's a video of a one pass rough cut. I'm > turning > > the spindle at about 100 RPM and the depth of the cut is 3.5 mm > > approximately. > > > > Here's the video: https://youtu.be/xjBXa6RHSPQ > > > > Nice. Cast iron cam shaft? Does it get hardened after? If so how? > John > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
