I went back through my steps to solve my problem, and found that the documentation for 2.9.0 pre does not show this new way of doing it.
--J. Ray Mitchell Jr. [email protected] (818)324-7573 "Good enough is the enemy of excellence"author unknown On Sun, Aug 16, 2020 at 7:35 PM jrmitchellj <[email protected]> wrote: > I see why I had trouble. It was easier that I emagined! > > Thank you Andy! > > --J. Ray Mitchell Jr. > [email protected] > (818)324-7573 > > > "Good enough is the enemy of excellence"author unknown > > > On Sun, Aug 16, 2020 at 12:47 PM andy pugh <[email protected]> wrote: > >> On Sun, 16 Aug 2020 at 20:41, jrmitchellj <[email protected]> wrote: >> > >> > Has something changed in Master with the process of setting tool length >> > offsets? >> >> A long time ago... >> >> Assuming the Axis GUI there are now two buttons, one to touch off the >> coordinate system and one to touch off the tool. >> (Because it was so easy to forget to select "tool table" in the drop-down) >> >> -- >> atp >> "A motorcycle is a bicycle with a pandemonium attachment and is >> designed for the especial use of mechanical geniuses, daredevils and >> lunatics." >> — George Fitch, Atlanta Constitution Newspaper, 1912 >> >> >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
