That board only works with a Raspberry Pi. In 10 years the Pi will be an antique and no longer supported by now Linux kernels. Better to buy a board that connects to any computer via a standard interface then you can always replace either the computer or the Mesa card.
On Tue, Aug 18, 2020 at 11:06 AM hubert <[email protected]> wrote: > Gene > > Just browsing the Mesa Website and ran into the Above card. > http://www.mesanet.com/pdf/parallel/7c80man.pdf. This made me think of > your Sheldon controller and left me wondering If this would have made > your project easier. If so I have a couple of lathes I might convert > after I finish my Mill upgrades. > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Chris Albertson Redondo Beach, California _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
