On Tuesday 18 August 2020 18:50:22 Frank Tkalcevic wrote: > > the middle of a now thicker and nuch denser 6 wall build. cura > > settings are for 6 line walls, 15 ipm and 30 ipm. > > 6 line walls/perimeters is a large number. My default setting is 2. > Less perimeters also prints a lot faster. If the part is weak, you > can always increase it later, but it sounds like you are still having > issue with the extrusion flow rate. > The 2 I broke already were made before I calibrated it and found it set for about 18mm of pla for a 100mm move. At 6, its buckets sturdier, but the bearing bottom was 35.5mm and I killed a bearing putting it together. So I've scaled it down a wee bit and will make another for the 3rd one if this one fits better.
Thanks Frank. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
