oops- meat to reply to list
offset-scale is set to appropriate (well....) value (if not,
eoffset-request stays 0 (guess how I know)).
On 3/10/21 11:58 AM, Leonardo Marsaglia wrote:
Hello Lloyd,
Did you set any input on the *axis.L.eoffset-scale *pin? May that's what
you're missing.
El mié, 10 mar 2021 a las 13:53, lloyd wilson (<[email protected]>)
escribió:
I'm having trouble getting the new 2.8 external offset functionality to
play nicely. Most of the (known) steps are working (as observed in the
hal watch screen):
- axis.a.eoffset-enable is set true.
- inputs (step up & down) generate appropriate values in
axis.a.eoffset-counts
- offset counts generate an (at least for first approximation)
appropriate value in axis.a.eoffset-request
- but the requested value never shows in axis.a.eoffset
OFFSET_AV_RATIO is set to 0.5 (just a swag for now).
other configuration values for this axis are cribbed directly from the
generic stepper example. The stepper motor responds appropriately to jog
commands.
I'm sure there is a (blindingly obvious) step I'm missing, can somebody
aim me in the right direction?
as always, thanks
lloyd
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
