Hello Dave, I never had any luck with dd on the original images, I always used the rip tools.
Andreas > Am 07.04.2021 um 17:52 schrieb Eric Keller <keller...@gmail.com>: > > Dave, > It sure sounds like you are failing at the first step, you shouldn't have > to dd, and it's probably not going to work. You don't have a linux computer? > Eric > > > On Wed, Apr 7, 2021 at 11:15 AM dave engvall <dengv...@charter.net> wrote: > >> Confusion reigns! >> The idea is to use the pi to drive a 7i90->7i33 >> I just tried the link John recommended .. 2.8.1 with the same result so >> it looks like I need to shift gears. >> I'm lost; I just need a version that will run linuxcnc with servos. >> Agnostic about which version. >> If raspianos with uspace(?) will do that I'm happy. I just need >> something to WORK. ;-) >> With some pain I can use my wife's Mac and the rpi-tools to get an >> image on to the SD. >> Wandering in the wilderness. >> >> Dave >> >> >> On 4/7/21 7:31 AM, andy pugh wrote: >>> On Wed, 7 Apr 2021 at 15:25, dave engvall <dengv...@charter.net> wrote: >>>> Image is one at top of page. buster 4 G >>>> https://raspi.debian.net/tested-images/ >>> Do you actually want to run LinuxCNC on the Pi? >>> >>> Why are you using the Debian image rather than the official Raspbian >>> one, or the LinuxCNC one. >>> >> >> >> >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
