Now that right there is amazing customer service 😍! On Mon, 26 Apr 2021, 9:04 AM Ralph Stirling, <ralph.stirl...@wallawalla.edu> wrote:
> Can't turn down a deal like that! I only need three analog channels. > > Thank you! > -- Ralph > > > On Apr 25, 2021 1:22 PM, "Peter C. Wallace" <p...@mesanet.com> wrote: > CAUTION: This email originated from outside the Walla Walla University > email system. > > > On Sun, 25 Apr 2021, Ralph Stirling wrote: > > > Date: Sun, 25 Apr 2021 17:43:12 +0000 > > From: Ralph Stirling <ralph.stirl...@wallawalla.edu> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <emc-users@lists.sourceforge.net> > > To: "emc-users@lists.sourceforge.net" <emc-users@lists.sourceforge.net> > > Subject: [Emc-users] Analog servo system > > > > Getting back to my Realmeca C2 mill retrofit now. > > I'm giving up getting the Fagor 8050 control going, > > so plan on retrofitting with LCNC. > > > > I'd like to use ethernet to a NUC-type computer. > > I'm looking at this chain of boards, but am not > > sure about compatibility of some: > > > > Mesa 7i94 eight-port smart serial to Ethernet > > -> 7i69 48 i/o sserial -> 7i33 analog servo (have already) > > -> 7i84 32i/16o sserial > > -> 7i73 pendant sserial > > > > My main concern is if the 7i33 will work with the > > 7i69, and if latency will become an issue with > > everything running over sserial and ethernet. > > > > The 7i94 is in stock at Mesanet, and the 7i69 > > and 7i73 are in stock at Mesaus. Some other > > approaches, like the 7i97, are not in stock. > > > > Thanks, > > -- Ralph > > > > > I have a 7I97 with one bad analog channel for free if you want it > > Peter Wallace > Mesa Electronics > > > > _______________________________________________ > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users