> -----Original Message-----
> From: Peter C. Wallace [mailto:p...@mesanet.com]
> Sent: June-10-21 9:38 PM
> On Thu, 10 Jun 2021, John Dammeyer wrote:
>
> > BTW, used the same process for the BBB to install mesaflash.
> >
> > Attached file shows the result. Works like a charm so the issue isn't the
> > mesaflash program and ARM libraries nor PC running LinuxCNC. The issue is
> > probably with the Pi4 libaries used by the mesaflash.
> >
> > John
> >
>
> I would think its more likely a host network setup issue. I'll try mesaflash
> on
> a RPI4 with a Ethernet card tommorow but I do know mesaflash works properly on
> SPI connected FPGAs card on the RPI4. (and linuxCNC runs fine with Mesa
> Ethernet
> cards on the RPI4)
>
> Peter Wallace
> Mesa Electronics
With the Beagle I didn't bother setting up the host. I shutdown the beagle.
Plugged in the Ethernet cable to the 7i92 and then started up the beagle. Once
(finally) running I did a ping to 192.168.1.121 and that worked. And so did
the rest of it.
BTW, the Pi4 1GB I'm running has successfully run LinuxCNC with a 7i92 and cut
metal. So the Ethernet connection to the Pi4 works for that. But maybe I
screwed up something while setting up the 7i92 Ethernet connection. I must
admit I haven't tried running LinuxCNC with it since.
And the Pi4 does properly ping the 7i92 and can ask if it's a 7i92. Looking
forward to your tests.
John
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
