Hi Andy,
is that an ISO? I have been looking around at the linuxcnc.org website, but don't see it.
Do you have a download url? thanks, Ron On 6/27/21 5:08 PM, andy pugh wrote:
LinuxCNC 2.8.2 has been released. This is mainly a bugfix release, though it also adds a new HAL component ("sendkeys") for creating input device events from HAL pins. All users are encouraged to update. In addition there is a new RTAI kernel based on 4.19.195. This comes with a new version of RTAI 5.3. Both should be automatically installed with the 2.8.2-rt version of LinuxCNC. If you are using the ISO install or know that you are running the preempt-rt kernel this need not concern you. Thanks to the following contributors: alkabal Chris Morley damiodj Dewey Garrett elovalvo Greg Carl Hans Unzner Håvard Flaget Aasen john Kiall Mac Innes McCodie NhanPham Norbert Schechner Phillip Carter Rene Hopf Sascha Ittner The abridged changelog: gladevcp: Numerous Updates qtvcp -cam_align panel: allow selection of camera number gmoccapy_3_1_3_8 - many updates Typo correction Axis.py "Geometry reading" XYZBCUVW > XYZABCUVW Docs add info on loading halscope update 2.8 from master for xhc-whb04b-6 Merge pull request #1024 from kiall/2.8-axis-error-pin translations - fixed moccapy / gmoccapy errors Update hostmot2.9 Fix: update manual SSI Update abs_encoder.c add info on installing mesaflash rx_mode typo in hm2_uart_setup Docs: Many updates flipflop: Add an inverted output pin, like the classic D-type latch pncconf -fix inverting of steppers, in the tune axis test qtvcp -qtaxis: change controls for lathe configs pyui -fix commands for joints/axis changes Docs: Correct pin direction 14 in the parallel port docs gmoccapy_translations - new translation files interp_o_word.cc: mdi-opened files leak #1088 command.c: use consistent external offset epsilon sendkeys: A HAL component to send keystrokes and UI events plasmac: fix material verter for sheetcam update fix halcompile singleton option on userspace components pncconf -fix internal description of 7i73 mode 1 pncconf -fix sserial number when parcing XML pncconf -fix sserial channel number for the 7i96 Docs: Update URL to updated Pi SD card image. Also document limitations. Merge pull request #1052 from Hans470/2.8-restructure-hal-doc pncconf -many uodates Added new version of Raspberry Pi4 and Raspberry Pi 400 AXIS: Add an axisui.error pin qtvcp -qtDragon docs: add a bit of information about probing. Update near.comp add {} for syntax coherence PlasmaC: Many Updates hal_glib -fix check_for_modes always failing emccanon.cc GET_EXTERNAL_TOOL_SLOT hdl bogus request Revert bad change inside driver XHC-WHB04B-6 lcnc 2.8
_______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users