On Thu, 27 Jan 2022, John Figie wrote:
Date: Thu, 27 Jan 2022 16:12:43 -0600
From: John Figie <zephyr9...@gmail.com>
Reply-To: "Enhanced Machine Controller (EMC)"
<emc-users@lists.sourceforge.net>
To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net>
Subject: Re: [Emc-users] mesa 7i80 configuration
which is not supported by LinuxCNC. The only SPI module supported by
LinuxCNC
is the buffered SPI module: BSPI. If you want to experiment with the BSPI
module, the 7i65 configurations contain that module.
OK that makes sense but where are these 7i65 configurations?
That is why I was asking about pin files a few days ago. In order to figure
out what these
bit files are I have to load them into the card and then read the config
out.
Are there any configurations that
have encoder inputs and BSPI channels?
regards,
John FIgie
7i80hd_25_2x7i65.bit has 2x BSPI and 16 muxed encoders
(which would work for testing even if
you don't have muxed interface hardware)
It sounds like you would want custom formware
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
Peter Wallace
Mesa Electronics
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
