The version running a 4 core GX-415 processor should be fine for
LinuxCNC. I use Wyse 5020 thin clients on my lathe and router, which
use the same SOC. The 2 core version is a bit slow if you are using it
with Ethernet FPGA cards. I used one on my lathe for a couple of years
and it occasionally popped up a latency warning, though the machine
appeared to run fine.
I have to admit I'm a big fan of thin clients. My workshop is pretty
damp and when I used desktop based PCs I probably averaged about 1
failure every year or so. Since swapping to thin clients about 5 years
ago I have had one failure and that was down to my carelessness, rather
than a spontaneous failure.
Les
On 10/02/2022 00:01, andrew beck wrote:
hey everyone
just wondering who has used the thin client computers
i am looking for a fanless pc that i can buy in oceania
https://www.youtube.com/watch?v=tVXn_fEbDTs
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
