On Tue, 12 Apr 2022, Marius wrote:
Date: Tue, 12 Apr 2022 16:22:37 +0200
From: Marius <mar...@mastercut.co.za>
Reply-To: "Enhanced Machine Controller (EMC)"
<emc-users@lists.sourceforge.net>
To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net>
Subject: Re: [Emc-users] Looking for 7i92 bit file
I attached a picture. Don't remember if that can be done.
This is the config I need but I will be damned if I can get PnCConf to do
this. Maybe I dont understand the GUI where the pin allocations happen that
well. If only they would show the I/O number correctly somewhere. There are
some numbers on the left side but they make no sense.
The pinout is determined by the firmware so many
parallel port type 7I92 bitfiles will do
For example 7i92_5ABOBx2D.bit firmware will work here
You associate stepgen numbers to Axis in pncconf
The firmware maps those numbered stepgens to
physical pins
XSTEP - 2 : XDIR -3
X2STEP - 4 : X2DIR - 5
YSTEP - 6 : YDIR - 7
NO Z (or 16 and 17)
ASTEP - 8 : ADIR 9
On 2022/04/12 15:50, andy pugh wrote:
On Tue, 12 Apr 2022 at 13:48, Marius <mar...@mastercut.co.za> wrote:
The config I have to replicate is this.
Seems to be coming through blank.
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
