Here are some pages about removing the motor and head for Series II interact 2
https://drive.google.com/drive/folders/0B2fj8HWg0FnNX1hjbGJpbTF0bDg?resourcekey=0-taJjv8naI-blsIgoBgwWEg John Figie On Sun, Jun 26, 2022, 1:11 AM <m...@mattshaver.com> wrote: > On 2022-06-25 18:30, Jon Elson wrote: > > On 6/25/22 15:56, Jon Elson wrote: > >> Hello, all, > >> > >> I just got an R2E3 Bridgeport mill in my basement, and will be doing a > >> LinuxCNC retrofit. > >> > >> I seem to recall the NC400 servo amps create a maddening squeal, is > >> that correct, or an I remembering some other system? > > The V2E3 I started with used to squeal mightily when the amps were > enabled. > > >> I had to pull the rigid ram and head off the machine as an assembly, > >> to clear my doorway. Does anybody have some hints on how to go about > >> reassembling that? My plan is to remove the Z servo and the spindle > >> motor, then take the head off the ram, install the ram back on the > >> base and then hoist the head back up on the ram. An issue with this > >> is that I have very limited ceiling height of about 92", so getting my > >> engine crane to lift it from above may be very difficult. One > >> possible plan is to lift the head onto the table with some kind of > >> cribbing and then use the knee screw to lift the hear into position. > >> > >> I am real familiar with the 1J head on my old mill, but don't really > >> know how to get the 2J BOSS-style motor off the head and varispeed. > >> Any suggestions on that are welcome. > > I think I have a (nearly?) complete set of books if that would help? > I'll dig around tomorrow! > > Thanks, > Matt > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
