Sorry wrong link in previous email. https://photos.app.goo.gl/SCAKjGBhPTQm1NKi9
On Sun, Jun 26, 2022, 7:00 AM John Figie <zephyr9...@gmail.com> wrote: > Here are some pages about removing the motor and head for Series II > interact 2 > > > https://drive.google.com/drive/folders/0B2fj8HWg0FnNX1hjbGJpbTF0bDg?resourcekey=0-taJjv8naI-blsIgoBgwWEg > > > John Figie > > On Sun, Jun 26, 2022, 1:11 AM <m...@mattshaver.com> wrote: > >> On 2022-06-25 18:30, Jon Elson wrote: >> > On 6/25/22 15:56, Jon Elson wrote: >> >> Hello, all, >> >> >> >> I just got an R2E3 Bridgeport mill in my basement, and will be doing a >> >> LinuxCNC retrofit. >> >> >> >> I seem to recall the NC400 servo amps create a maddening squeal, is >> >> that correct, or an I remembering some other system? >> >> The V2E3 I started with used to squeal mightily when the amps were >> enabled. >> >> >> I had to pull the rigid ram and head off the machine as an assembly, >> >> to clear my doorway. Does anybody have some hints on how to go about >> >> reassembling that? My plan is to remove the Z servo and the spindle >> >> motor, then take the head off the ram, install the ram back on the >> >> base and then hoist the head back up on the ram. An issue with this >> >> is that I have very limited ceiling height of about 92", so getting my >> >> engine crane to lift it from above may be very difficult. One >> >> possible plan is to lift the head onto the table with some kind of >> >> cribbing and then use the knee screw to lift the hear into position. >> >> >> >> I am real familiar with the 1J head on my old mill, but don't really >> >> know how to get the 2J BOSS-style motor off the head and varispeed. >> >> Any suggestions on that are welcome. >> >> I think I have a (nearly?) complete set of books if that would help? >> I'll dig around tomorrow! >> >> Thanks, >> Matt >> >> >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > John Figie _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
