On 10/28/22 13:50, andy pugh wrote:
On Fri, 28 Oct 2022 at 18:33, John Dammeyer <jo...@autoartisans.com> wrote:
Again though, how easy is it to run a threading operation G-Code that ignores
spindle RPM?
Very difficult, as the threading motion mode explicitly servos the
moving axis to the spindle encoder.
If you were to disconnect the spindle gears so that the encoder still
turned it would be an option.
Take the chuck off, and put a cnc'd BS-1 in front. and let the spindle
turn air.
Figure on cutting one spline by writing your code so the threading G76
to cut the spline,
is a subroutine you call from the main loop which sets the angle for
the splines cut. 50
lines of code max if even that.
Cheers, Gene Heskett.
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author, 1940)
If we desire respect for the law, we must first make the law respectable.
- Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/>
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
